scan function, and then those channels which set automatic scan will be activated by it-self. For
instance, if the scan function of channel 3,5,7 was activated by PC software programming, when
you rotate the channel selector to channel 16, the transceiver will scan channel 3,5,7,16, when
receive signal from one of these four channels, it will stop scanning, and talk on this channel.
It’s normal that it will be delayed when you open the speaker after activating the scan function,
the delay time is related to the number of channels which set scan function.
Note:
If the channel with CTCSS/DCS, if it is disturb by signal with CTCSS/DCS or not during scanning,
the radio light will bright green and quit scan. The speaker is also without sound. It must wait for
10 seconds after the interference, which is normal.
Busy Channel Lockout
1. Open the PC software to select the channel you require. NF-910 can be set to be OFF, carrier
wave and QT/DQT busy lockout
2. CTCSS Busy Lockout: The transceiver receives SQ, but not QT/DQT, and then transmitting is
allowed. The transceiver receives SQ, and QT/DQT and then transmitting is prohibited.
3. Carrier Wave busy lockout: The radio receives SQ and it is prohibited.
Power Save
Open the PC software to decide whether you select the power saves or not. When ”on” is chosen,
that means you the power save function being turned on.
17
Summary of Contents for NF-910
Page 22: ...Appendix CTCSS and DCS chart 21...
Page 23: ......
