![background image](http://html1.mh-extra.com/html/namco/ridge-racer-v-arcade-battle/ridge-racer-v-arcade-battle_operators-manual_3186458061.webp)
Page 61
8-3 Replacing the Steering PCB and/or Fuse
1.
Remove 8off button head screws (M5x12) and remove the Monitor Cabinet
Rear Cover.
2.
Replace the fuse or:
3.
Disconnect the six connectors shown shaded in the diagram below.
4.
Loosen 2off pozi head screws (M6), lift the PCB Base to disengage it from
the screws and remove the PCB with the PCB Base.
5.
Remove 4off pozi head screws (M3x12), with flat and spring washers, and
remove the Steering PCB.
6.
Reassemble in reverse order.
Note: When refitting the PC Base ensure that the tab at the bottom of the PC
Base engages in the slot in the cabinet.
(+)Phillips pan head screw (with flat/spring washer) (M3 x 12)
PCB base
Connector
Countersunk nut (M6)
Steering PC board
Fuse
2P side
(The 1P fuse is on the
other side of the panel.)