![background image](http://html1.mh-extra.com/html/namco/ridge-racer-v-arcade-battle/ridge-racer-v-arcade-battle_operators-manual_3186458005.webp)
Page 5
50cm or more
50cm or
more
Play zone
Pathway
2m 20cm or more
30cm or more
30cm or more
2m 20cm or more
1m or more
REMOVING AND REPLACING PARTS
Adjustments or maintenance on this equipment should be carried out by suitably qualified
personnel only.
Do not make any alteration to this equipment without prior approval. Doing so could cause
unforeseeable danger.
Only parts specified by Namco Europe Ltd. should be used when replacing parts. (Including
screws)
Ensure that the power to the equipment is turned OFF before commencing any maintenance work.
(Trouble shooting, repairs etc.)
If performing work not described in this manual, contact your distributor for instructions, as no
responsibility will be accepted for damage or injury.
Parts of the Power Supply and Monitor remain hot and carry high voltage even after switching OFF
and could cause burns or electric shock. Take care not to touch these parts accidentally.
Make sure that the equipment is switched OFF before connecting or disconnecting any plugs or
connectors.
When moving the mains connector from the equipment, or the mains plug from the wall outlet,
always grasp the plug and not the cable.
NOTES ON INSTALLATION
NEVER turn the power to the machine ON until installation has been
completed.
In order to prevent possible electric shocks, be sure that the
equipment is connected to the mains with a securely connected
earthed plug.
In order to avoid damage to the equipment due to mis-operation, ensure
that the voltage of the mains supply is 230volts AC.
Note: If the location of this equipment has a polished floor, it is recommended
that rubber pads are fitted under the level adjusters to prevent the
equipment sliding on the floor when in use.
Note: In order to gain access to the Power Supply and CPU assemblies, ensure
that the rear of the equipment is seperated from a wall or other equipment
by at least 500mm
MOVING THE MACHINE
This machine is fitted with castors to make it easier to move. Take care when moving the machine on an
inclined surface.
The Header Assembly has a forward centre of gravity, so it is important that at least two people are used to
fit or remove the Header Assembly.
The fitting position of the Header Assembly is high, and it is important that a means of reaching the height
safely,without stretching, is available. (e.g. Steps, Step Stool etc.)
The overall height of the machine, with the Header Assembly fitted, is 1990mm. Take care of any overhead
obstructions. (e.g. Light Fittings, Electric Cables etc.)
When moving the game, ensure that the game is dis-assembled into 3 parts: Monitor Assy, Ride Assy and
Header Assy.