NAL Research Corporation (TN2012-02-V1.0)
54
+CAR: (list of supported values of <n>)
A.8.93 In – Identification
Requests the A3LA-RS to display information about itself.
0
“2400” (traffic channel rate for IRIDIUM data/fax)
1
“0000” (ROM checksum which is not supported so zero is output)
2
“OK” (result of ROM checksum verification which is not supported so OK is always
output)
3
“XXXXXXXX” (Software revision level)
4
“IRIDIUM” (Product description)
5
“XXXX” (Country code)
6
“XXX” (Factory identity)
7
“XXXXXXXX” (Hardware specification)
A.8.94 +CIER – Indicator Event Reporting
Set Command:
+CIER=[<mode>[,<sigind>[,<svcind>]]]
The set command enables or disables sending of the +CIEV unsolicited result code by the A3LA-
RS in case of indicator state changes. <mode> controls the processing of the +CIEV unsolicited
result codes.
<mode>:
0
Disable indicator event reporting; do not send +CIEV unsolicited result codes to the
DTE; buffer the most recent indicator event for each indicator in the A3LA-RS.
(default)
1
Enable indicator event reporting; buffer the most recent +CIEV unsolicited result
code for each indicator when the data port is not in command mode, and flush
them to the DTE on return to command mode; otherwise forward events directly to
the DTE.
<sigind>: Control reporting of “signal quality” indicator changes.
0
No “signal quality” indicator reporting
1
Enable “signal quality” indicator reporting using result code +CIEV:0,<rssi>
where <rssi> is:
0
Equivalent to 0 bars displayed on the signal strength indicator
1
Equivalent to 1 bar displayed on the signal strength indicator
2
Equivalent to 2 bars displayed on the signal strength indicator
3
Equivalent to 3 bars displayed on the signal strength indicator
4
Equivalent to 4 bars displayed on the signal strength indicator
5
Equivalent to 5 bars displayed on the signal strength indicator
When enabled, the signal quality indicator is reported only when the signal strength
changes.
<svcind>: Control reporting of “service availability” indicator changes.
0
No “service availability” indicator reporting
1
Enable “service availability” indicator reporting using result code +CIEV:1,<value>