Page | 39
Main Button
MAIN +/-
Hold
Holding or unlatching the main button will cause the
retraction sound to play and then the saber will return to Idle
mode.
Main
Hit saber
MAIN +/-
Hold + Clash
Holding the main button and then immediately performing
the clash action while still holding the main button will
perform the EzLockup™ feature, bypassing the clash and
going right to the lockup. This ensures the clash will perform
using the specified clash color.
Table 5 – Interactions possible when the saber is running, and a single button is being utilized.
7.3.
SABER TRACKS
The menu in Spark 3™ cycles through each of the 3 fonts, and then to the special Saber Tracks font, before cycling
back to the first font. After hearing the “Saber Tracks” audio clip in the menu, you will immediately be entered into
Saber Tracks™ mode and the first track will immediately start playing. In Spark 3™ all the
TRACKNN.WAV
files go in
the
/tracks
folder right off the root of the micro SD card.
New in R3 – Saber Tracks™ now has the ability to engage the blade while the music is playing! After hearing the
music start, you can either press and hold the main button (if it is momentary) or latch the main button (if it is
latching) to ignite the blade. The extension effect will occur followed by the pulsing of the blade. No additional
effects will be displayed, and now sound effects will play, but the music will stream non-stop.
The blade color and pulse for Saber Tracks™ in Spark 3™ will be selected from the last used font. This means that
Saber Tracks can be used with any of the 3 blade colors for each of the 3 fonts.
To turn off the blade, simply hold the main button (if it is momentary), or unlatch the main button (if it is latching).
Holding the aux button or doing the twist motion for a single button install will exit Saber Tracks and load the first
font.
7.2.3.
SABER TRACKS INTERACTIVITY
The following table describes the interactivity for Saber Tracks.
Entry
Label
Action
Description
Aux Button
AUX +/-
Press
Advances to the next track. When the last track file is reached
it goes back to the beginning.
Main Button
MAIN +/-
Hold/Latch
Holding or latching the main button will enable the blade,
doing the extension effect first then the pulse effect.
Main Button
MAIN +/-
Hold/Unlatch Holding or unlatching the main button will cause the blade to
retract if the blade is current enabled.
Aux Button
AUX +/-
Hold
Holding the aux button will exit Saber Tracks™ and load the
first font.
Table 6 – Interactions possible when two buttons are installed and Saber Tracks is engaged.
When One Button is enabled in the master section, the following defines the interaction
Entry
Label
Action
Description
