ND - 101-8 / ND - 101CT-8 CENTRAL UNIT MOUNTING
FIGURE-1.15 : PULLING CENTRAL UNIT’S SCREWS
While the electricity is turned off, pull the screws with the
screwdriver as shown in FIGURE - 1.15.
While the electricity is turned off, pull over the front
cover in the direction of arrow as shown in FIGURE -
1.16 after you have pulled the screws.
FIGURE-1.16 : REMOVING CENTRAL FRONT COVER
FIGURE- 1.18
2
3
CENTRAL UNIT
SLED COIL
SILED
1
RAIL
For the mounting of central unit to the rail, as shown in FIGURE- 1.18
place the central unit to the rail after you make sure that the rail
falls into well to the holes on the back of the central unit. Push the
“SLED” inwards from the space in the middle of the central unit. After
finishing this process, place the “SLED COIL” in the coil hole situated
on the sled.
RAIL MOUNTING
TECHNICAL CHARACTERISTICS
85-265VAC / 50-60 Hz
+24V DC
±
1V
3.5 A max
-20°C - +40°C
IP20
Input Voltage
Output Voltage
Output Current
Operating Temperature
Protection Class
Fix the wall mount apparatus to the wall as shown figure
1.17-A, then mount it by screws.
Set ID values by using DIP switch and insert the cover back.
Please refer Section2 for ID ranges.
WALL MOUNTING
5
FIGURE- 1.17-B CCTV SETTINGS
A
B
C
A- Central Unit’s CCTV Settings
B- CCTV Electronic Board
C- CCTV Setting Switch
Let the central unit informed with total CCTV number by
dipswitch whics is placed on CCTV board, shown in Figure-
1.17-B. Please refer to Section-2 Table-2.2 for defination of
CCTV number.
FIGURE-1.17-A MOUNTING SCREW HOLES and ID SWITCHES
Summary of Contents for V-BUS7
Page 2: ......
Page 50: ...45 FARKLI BA LANTI UYGULAMALARI BÖLÜM 10 ...
Page 68: ......
Page 116: ...45 DIFFERENT WIRING COMBINATIONS SECTION 10 ...