- 45 -
PAL Voltage Regulator 6 V
Fig. 28
The PAL 6 V regulator and the mechanical setting of the individual contact
gaps is the same as that of the 12V dynastart regulator. The difference between the
6V and l2V regulators is in the voltage and current coil winding which is always
adapted to the voltage. Always check the mechanical setting of the regulator
according to the diagrammatic illustration where the individual regulator contacts are
marked. In the table, the gap values between the individual regulator contacts will be
found. /See Paragraph Dynastart
– Mechanical check of the regulator with contactor.
Checking the charging by voltmeter connected to the dynamo terminal 61 and
the machine frame with the fuse removed and the ignition key in position 5 / switch
box with ampere meter or position 1 /car - type switchbox /. At approx. 1200 r.p.m.
the regulator armature will connect - voltage 6.5 ± 0.3V. At 4500 to 5000 r.p.m.
voltage 7.8 ± 0.3V. This value must never be exceeded! Any charging setting is to be
done with the regulator nut #8.
Checking with the ampere meter connected instead of the fuse. Ignition key in
position 1, approx. 1200 r.p.m., 6.5 ± 0.3V value 5 amps. Ignition key position 3
/headlamp main beam/, 4500 to 5000 r.p.m. - 7 ± 0.3V - 1 to 2 amps / values with
fully charged battery/.
Fig. 28
Summary of Contents for 501/01
Page 1: ...orkshop anual This manual covers all Cezeta and N Zeta models M W ...
Page 12: ... 11 Fig 2 ...
Page 20: ... 19 Fig 7 ...