- 22 -
After pushing out the carbon brushes, take the dynastarter out of the crankcase.
Slacken the cam bolt #1 and tap the cam lightly from side to side taking care not to
mark it and remove it from the shaft. Screw puller S-49 or a long M10 bolt /one can
be obtained from under the luggage compartment securing the rear suspension unit
to the bodywork/, into the hole in the centre of the rotor. Turn the bolt while holding
the rotor with the other hand until the rotor slides off the shaft. To reassemble,
proceed in reverse manner.
To Dismantle The Clutch Operating Bracket.
Remove the RH crankcase side cover. Free the clutch cable after that.
Unscrew the three bolts and remove the bracket with levers. Remove from the
1
2
3
4
5
6
10
Fig. 10
Summary of Contents for 501/01
Page 1: ...orkshop anual This manual covers all Cezeta and N Zeta models M W ...
Page 12: ... 11 Fig 2 ...
Page 20: ... 19 Fig 7 ...