N-Zeta 501/01, Workshop Manual

Page: 26 / 53

- 25 -
To Remove The Kick Starter Quadrant.
Remove the kick starter quadrant together with the return spring from the gear
change shaft. Take care of the return spring when taking the parts off . Further
remove the spacer which is on the gear change shaft. To assemble, proceed in the
reverse manner. When refitting the quadrant on the gear change shaft, first insert the
return spring into the groove in the crankcase by rotating the whole quadrant
clockwise.
To Dismantle The Gear Change Shaft
The gear change shaft can be removed after the RH crankcase side cover
and the clutch operating bracket have been taken off. Using the punch S-44, drive
out the cam securing pin from below Fig.
15 and remove the cam. Take care of the
shims between the crankcase and the
cam. From the clutch side, put the pawl
securer S-51 Fig. 16 onto the gear change
shaft. To assemble, proceed in the reverse
manner taking care of the pawls which are
spring loaded and have to be secured
again with the S-51 tool. The cam securing
pin must always be driven in from above.
Fig. 15
Fig. 16