12/1/2006
21
o
dtr
Dialout session is terminated when DTR signal on the serial port s0 toggles from High to Low
o
none
Dialout session is not dependant on the DTR signal Default: none
Modem Configuration
•
Connect String: Sets the Modem Connect string
Default: CONNECT
•
OK String: Sets the Modem OK string
Default: OK
•
Hangup String: Sets the Modem hang-up string
Default: +++ATH0
•
Ring String: Sets the Modem Ring string
Default: RING
•
Dial Prefix: Sets the Modem Dial-Prefix
Default: ATDT
•
Dial Suffix: Sets the Modem Dial-suffix
Default: ^M
•
Dial Number: Sets the dial-number to be dialed Default: NULL
•
Dialing method: Sets the modem dialing method
Description
o
Configuration method: User shall provide only the dial-number to reach
o
Chat-script method: User can write his/her own script by providing an "Expect" and a "Send" sequence
Refer to: chat-script for providing an "Expect" and a "Send" sequence
Default: configuration
•
Init String: Configure the Modem init strings
Init-num can range from 1-5
Chatscript
•
Sets/Clears expect and send strings for the chat script to act on the modem
Bridge Configuration
•
Bridge: Enables/disables remote transparent bridging between ethernet and serial interface. Enabling bridge will automatically enable telnet, tftp services on
the module. Disabling will automatically disable PPP on the module
Default: disable
•
IP Address: Sets Bridge IP address. Can be set only when Bridge is enabled
Default: Ethernet ip address
•
IP Mask: IP mask of the configured IP address
PPP Configuration
•
PPP :Enableis/Disables PPP on the serial port s0. PPP can be enabled only if bridge is enabled
Default: disable
•
Compression:Enables/Disables CCP compression for PPP
Default: disable
•
Compression Type: Sets the compression type to bsd, deflate or both
o
PPP in non raw-mode:
When "both" is configured as the compression type, the module tries to negotiate deflate first. In the event of failure, the bsd is negotiated
o
PPP in raw-mode:
Compression type "both" is not supported in raw-mode, since there is no negotiations between SocketEthernet IP Modules
Default: deflate
•
Raw Mode: Enables/Disables simple AHDLC framing on the Serial side. In Raw mode, no PPP negotiations are done on the serial. The ethernet data is
encapsulated with 7E delimiters. FCS is part of the AHDLC frame header
Default: disable
•
Authentication: Enables/Disables PPP authentication
Default: disable
•
Authentication Type: Sets the authentication protocol type to negotiate with the remote peer: pap/chap/pap-chap
Default: pap
•
Username: PPP username with which remote peer will authenticate
Default: ipmodule
•
Password: PPP password with which remote peer will authenticate
Default: ipmodule
(continued…)
IPGeneral
•
Hostname: Sets the hostname for the module
Default: SocketEthernetIP
