2014 Mytrix Technology
All rights reserved Third Version
36
3. Retraction distance: the length of filament. These two parameter will only valid when
choose retraction allow in the general setting.
Effect:
If the length of the retraction filament is too short, it will possibly lead to over-
pulled, if it is too long, the filament might be able to be loaded.
4. Initial layer thickness: thickness of the first layer.
Effect:
The thicker the first layer is, the more adhesive the model will be.
5. Cut off object bottom: some models have an uneven bottom or lack off contact
surface, the bottom can be cut off partially.
Effect:
For those models that doesn’t matter much with the bottom or need to be printed
separately, it can be cut off to print, the print outcome will turn out better.
6. Dual extrusion switch amount: double print matters. When setting the double print,
repeat the extrusion variable.
Effect:
By setting a certain amount of repeat extrusion variable, two colors will be
adhesive to each other better.
7. Travel speed: the speed of the machine moving.
Effect:
The faster it moves, the shorter it costs for printing.
8. Bottom layer speed: the print speed of bottom layer, slow speed can make the print
more adhesive.
Effect:
Slow down the print speed of bottom layer appropriately enable the bottom
adhesive better, in this way, the print effect will come out better.
9. Infill speed: the speed of print filling.
Effect:
Speed up the filling enable print faster.
