Page 12 of 19
Pairing Devices and Accessories
1.
With the MXD-LTE turned on, press and release the MODE button on the rear of the MXD-LTE
base unit twice. The base unit will announce,
“Zone One, Pair Device.”
2.
Select a zone by briefly pressing and releasing the HELP button on the base unit to advance to
the next zone. The base unit will announce the next zone number.
Example: “Zone Two, Pair
Device.” “Zone Three, Pair Device.” etc…
The zone selection will start over once the last zone is
reached.
3.
Once the desired zone is selected, pair each device for the current zone by activating the device.
The MXD-LTE will automatically detect the device type and state that the device has been
paired.
CAUTION:
If the newly paired device has a low battery, the MXD-LTE will announce “low
battery.” Please notify your provider.
4.
If other devices and/or zones are desired, repeat step two and three until all devices are paired
to the desired zone
. If an already paired device is activated during the process, the MXD-LTE
will move it to the zone that is selected at that time.
5.
After all the accessories have been paired, press the RESET button once. The MXD-LTE will
announce, “
System Ready.”
This completes the pairing sequence, and each device should now
be paired to the MXD-LTE.
6.
Test all paired devices ONE AT A TIME by activating each and allowing the unit to call the
response center. Wait to start the next device test until the unit has disconnected from the
previous test call. Check carefully with the response center attendant to verify that each
accessory has been paired into the correct zone.
7.
If each test call is successful, the devices are ready for service. Re-pair any devices into the
desired zones that do not activate the base station when pushed.
Delete or Remove Accessories
The following describes how to remove paired devices from the MXD-LTE. It is important to remember
that this procedure removes ALL devices from the list of the selected device type.
Note:
all the specified
device types
are removed at once. You cannot remove only one specific device at a time.
To remove paired accessories, perform the following steps:
1.
With the unit turned on, press and release the MODE button on the rear of the MXD-LTE base
unit three times. The base unit will announce “Hold help to delete Wireless help buttons.”
2.
Briefly pressing the Help Button will advance the unit to the next accessory type as follows:
a.
“Hold help to delete smokes.”
b.
“Hold help to delete CO.”
c.
“Hold help to delete Medication Device.”
d.
“Hold help to delete Aubree Voice Recognition.”
e.
“Hold Help to delete Wireless help button.”
•
The MXD-LTE continues to cycle through the this list until Reset is pressed.
3.
Once you have selected the type of accessory you would like to remove from the unit hold the
help button on top of the unit until it states that devices of the specified type have been
removed. This usually takes about 5 seconds. Please take in to account that all the specified
device types
are removed at once. You cannot remove only one specific device at a time.
a.
For example, if there are five PHBs paired, all five will be removed at once.
b.
If a specific device needs to be removed, the other four PHBs need to be paired again
after they have been removed.
