Menus
operation and installation manual
zappi
19
Battery:
If an AC battery is being monitored the batter power
reading is shown:
Discharging (+) Charging (-)
Britain GMT/BST
The set time zone
LOC:
Local time
UTC:
Coordinated Universal Time
Readings 5/9
CP (Control Pilot) related debug information
Readings 6/9
DSR related debug information
Readings 7/9
Power Readings
Debug screen in preparation for automatic switching
between a single phase and three phase charging
Readings 8/9
Packet Counters
Displays activity over the wireless and Ethernet links
Information…
Information 1/5
Status:
Status of the unit
Serial No:
Serial number of the unit
Firmware:
Firmware version installed in the unit
Assembled:
Factory assembly date
Cal Date:
Calibration changed date
Power Fail:
Time and date of last supply failure
Information 2/5 Grid Sensor:
Grid current sensor source
Last Fault:
Last recorded fault code
Fault Date:
Date and time of last recorded fault code
zappi
1ph
Untethered
zappi
1ph Tethered
zappi
3ph
Untethered
zappi
3ph Tethered
zappi
3ph!
Identifies the
zappi
type, e.g. 3 phase or single phases
/ tethered or untethered.
A '!' mark shows a missing phase for 3 phase units
Information 3/5 Network ID:
Network information for this device when linked to
other devices using
myenergi
radio frequency (RF)
network (Only shows if connected to other devices)
Device Address:
Master Address:
Channel:
EUI:
MNID:
EV: Active:
Auto updates on 3 phase
zappi
s following the first
charge session to indicate if the EV is capable of
charging with 3 phases and whether 1 phase or 3
phase charging is active
Information 4/5 Time:
Current time
Date:
Current date
Up Time:
Length of time passed since last switch on
Network load control limiting information: