© GBC Films Group April 2000
Voyager Operation and Maintenance Manual
Page 1 - 50
Troubleshooting
Trouble
10. Snap Rollers Activating but
Not Separating or Partially
Separating
11. Electrical Malfunctions
Component Not Functioning
Cause / Action
a. Snap adjusting valves ( flow controls ) not properly
adjusted.
b. Skew wheel applying too much or too little bow to the
web
c. Exit roller is not applying enough draw pressure to the
left side of the web
d. Insufficient nip pressure applied at laminating process
e. Insufficient nip pressure applied at nip or draw roller
f. Knicking knife not cutting film at lap or cutting into paper
after knicking lap. This condition can happen is lap varies greatly.
g. Full bleed of ink and / or coating of sheets
h. Worn snap roller, exit roller or skew wheel
i. Poor adhesion
j. Poor film quality
a. Fuse or circuit breaker blown
b. Disconnected wire
c. Component opened electrical
d. Push reset button
ELECTRICAL
S H O C K
Electrical troubleshooting should be
left to qualified technicians!
Electrical shock hazard!