MX Atmos Traditional, Fitting Instructions Manual

Page: 9 / 16

CAUTION
Check there are no hidden cables or pipes before drilling holes for wall plugs.
Exercise great care when using power tools near water.
The use of a residual current device (RCD) is recommended.
!

!
!

!
11. FITTING THE RISER RAIL AND HANDSET
1.
Establish height of riser rail to suit users
requirements (Fig 1).
2. Disassemble the riser rail so you are left with the
tube only. Site riser rail on wall and with the use
of a spirit level ensure rail is vertical.
3. Mark the hole position on the wall measuring
from the pre-drilled holes in the riser rail. Drill
hole in wall and insert wall plug, screw lower
bracket to wall (Fig 2).
Drill hole in wall for the upper bracket, add wall
plug then screw wall bracket plate to wall.
4. Reassemble height adjuster onto riser rail
ensuring cone hole is the correct way aroundto
hold the handset (Fig 3).
5. Slide riser rail through top bracket pushing
higher than necessary. Screw wall bracket to
bottom wall bracket plate. Slide riser rail tube
through bottom bracket then fix end cap to both
brackets.
6. To fit the handset, connect one end of the double
interlock hose to the outlet on the mixer valve,
making sure that the sealing washer is in place.
7. Screw the remaining end of the double interlock
hose to the handset making sure the sealing
washer is in place, then locate the handset into
the handset height adjuster (Fig 4).
NOTE: It is the conical end of the double interlock
hose which grips into the handset height adjuster.
The handset will not fit in the height adjuster without
the double interlock hose attached.
TIPS
• A piece of insulating or masking tape applied
to the wall before marking out the fixing
holes will help stop the drill from wandering,
particularly on tiled surfaces.
!

!
1
2
3
4