46
M1.2.BB200.NLFREN 13112018
EN
10 Balancing operation of wheel
10.1 Balance mode change operation
1. Dynamic and static balance mode switch: press F key.
Dynamic balance mode: clip counterweight on inside and outside edge of rim (balancer tolerant normal balance mode),
ect figure 10-1.
ST mode: static balance measure mode, stick counterweight on middle of rim, ect figure 10-2.
2. ALU balance mode switch key (ALU key), switch CPU system between ALU-1~ALU-S mode.
Fig. 10-1
Fig. 10-2
Fig. 10-3
Fig. 10-4
Fig. 10-5
ALU-1 mode: stick counterweight on inside and outside of spoke of rim, ect fig. 10-3.
ALU-2 mode: clip counterweight on inside edge of rim, stick counterweight on outside (inside of spoke), etc figure 10-4.
ALU-S mode: This is a special balance mode (include ALU-1 and ALU-2), for counterweight split and hidden-stick mode:
ALU-S mode, if the outside (inside of spoke) counterweight position between of two spokes, ALU-S mode can split the
counterweight for two. The divided counterweight, just place on the back of two spokes near the former counterweight, in
order to hide the counterweight, ect figure 10-5.
10.2 Normal balance mode operation process
1. Follow chapter 7.2 input date of rim.
2. Lay down protect hood and press START key, wheel spinning, after stop two side LED display wheel both side imbalance
weight, when middle LED display OPT, can choice imbalance optimise.
3.
Slowly spin wheel, when inside counterweight position indicator light(figure 5-1(3)) all on, clip correspond counterweight
on 12 o’clock position on inside of rim, ect figure 10-6.
4.
Slowly spin wheel, when outside counterweight position indicator light(figure 5-1(4)) all on, clip correspond counterweight
on 12 o’clock position on outside of rim, ect figure 10-7.
copyrighted
document
- all
rights
reserved
by
FBC
