AccessZone ® - GC500 Series – GC501-GC504 User Manual
6
LED Status
The GC500/GC600 series have 3 internally controlled LEDs (Blue,
Green and Red) and two externally controlled LEDs (Red and
Green) for system indications.
The Green LED (mid) is a dual LED with an additional Red
LED controlled though input 3 (Orange core)
The Red LED (right) is a dual LED with an additional Green
LED controlled though input 4 (Blue core)
6.1
Power Up
The Blue LED and Red LED will light for 2 seconds from power up. This is the bootloader waiting for
new firmware. Will call the application if new firmware is not received.
6.2
Blue LED
Normal Mode - the Blue LED is solid on. It flashes shortly when any Bluetooth device ID is read
from a nearby Bluetooth device (e.g. a mobile phone).
Configuration Mode - the Blue LED blinks 1 time/sec. The device can accept commands
6.3
Green LED / Ext. Red LED
The Green LED starts blinking when waiting for user to enter the PIN code.
The Green LED is solid on during door/gate activation else it is off.
The ext. Red LED is by default OFF (leave not connected). It can be controlled from external
controller through input 3 (Orange Core). The LED is set ON by pulling it down to GND.
6.4
Red LED / Ext. Green LED
The Red LED is showing the status of the alarm/light control output. If Red LED is on the alarm is
armed/light is off. It goes off when alarm is disarmed/light is on.
The ext. Green LED is by default OFF (leave not connected). It can be controlled from external
controller through input 4 (Blue Core). The LED can be set ON by pulling it down to GND
All information is subject to change without notice. All other products and brand names are registered trademarks of their respective companies
2010-07-06 US 1.17
Copyright © 2005-2010 All rights reserved MVC-Data ApS Skalhuse 5 9240 Nibe Denmark Web
www.mvc-data.com
Phone +45 25 12 84 02
9/34
Dual LEDs