Set 1: User Type 75
PF2: Initial Change
PF3: Confirm Print
• After the confirmation adjustment printing, cut the media.
• With a ruler, measure the length between “
” in the pattern.
In the example below, the measured place is shown in orange dotted lines and arrows (the orange parts are not actually
printed).
• If the measured length does not match the feeding length, re-correct with
.
• If the measured length matches the feeding length, proceed to
Use the [+] / [ - ] key to enter the adjustment value, and press the [Enter] key.
Setting values
You can set a value that is b50 mm
and -50 mm of the feed length configured in
"Initial Print".
Pressing the [Enter] key when the words on the left are displayed will execute confirmation
adjustment printing.
Setting values
100 mm to <250 mm> to 500 mm
<> indicates the initial value.
Note
The length of media that is fed (feeding length) for confirmation adjustment printing, is normally set at 250 mm.
If you increase the feeding length, the accuracy of the Media feed adjustment improves.
To change the feeding length, press the [+] key or [ - ] key on Operation panel and change the set value.
PF2 :
Initial Change
Init. :
250.0 mm / 250 mm
PF3 :
Confirm Print
Feed Length :
250 mm
