Panel setup menu 63
Steps
1.
Select “PF1: Initial Print”.
•
“Feed Length: 250 mm” is displayed on Operation panel.
2.
After the initial adjustment printing, cut the media.
•
Measure the distance between the “
” in the initial adjustment print using a ruler.
3.
Refer to Chapter 1
"Media feed adjustment steps" P. 42
and select “PF2: Initial Change” on the operation panel.
4.
Press the [+] key or [ - ] key on Operation panel and enter the measured value in Step 2.
•
Press the [Enter] key to save the initial adjustment value.
5.
Press the [+] key or [ - ] key on Operation panel to select “PF3: Confirm Print”.
•
“Feed Length: 250 mm” is displayed on Operation panel.
6.
After the confirmation adjustment printing, cut the media.
•
Measure the distance between the “
” in the confirmation adjustment print using a ruler. Then, confirm
that the distance matches the feeding length when printing.
•
If the distance does not match the feeding length, follow the procedure from Step 1 to Step 5 and readjust.
•
If the distance matches the feeding length, proceed to Step 7.
**>3: PF Adjust
Sets up various settings on the Media feed correction.
When the following defects are found in printing results, they may improve by
conducting a media feed correction.
• Images are overlapping.
• There are white lines in images.
Submenus
* *> 3:
PF Adjust >
PF1 :
Initial Print
PF2 :
Initial Change
PF3 :
Confirm Print
PF4 :
Micro Print
PF5 :
Micro Change
