MUTOH ValueCut II Series, User Manual

Page: 66 / 112

Automatic Aligning System ValueCut USER MANUAL
66
VC2E-A-00
5.6 Tips for AAS
For getting better results of contour cutting, there are some tips below for your reference.

Keep light sources simple and avoid illuminating from the sides of cutter.

Adjust the cutting speed to between 300 ~ 600 mm / sec.

Avoid the registration marks locating on the tracks of pinch rollers.

Make sure the edge of the media is not bent up when detecting registration marks.

By adjusting the location of the cutter holder to the inside of the corner of the registration
mark, AAS sensor can smoothly detect registration mark.

If you are using media with lamination, the AAS sensor may not scan the registration marks
correctly.

If failed to scan the registration marks, try rotating the media by 180 degrees to load it onto
ValueCut, then send the cutting job file again.