Control Panel
ValueCut USER MANUAL
42
VC2E-A-00
[ ONLINE/OFFLINE ]
1. To switch between online mode and offline mode.
2. To stop the cutting job or abort the change of setting.
Once press this key, the cutting job will be terminated
immediately and cannot be resumed.
[ OFFSET ]
To set or modify the distance between the blade tip and the
center axis.
Please refer to section 4.3 or Chapter A-2 for more
information.
0.000~1.000 mm 0.250 mm
[ FORCE ]
To set or modify the value of tool force.
When the cutting force exceeds 450g, the maximum cutting
speed would be 15cm/sec and the cutting quality would be
Small Letter Mode (0.2g) and while the cutting force is
300g-449g, the maximum cutting speed would be 30 cm/sec
and the cutting quality would be Fine Mode (0.5g)
5~600 gram;
5 gram / step
80 gram
[ SPEED ]
Speed
To set or modify tool down speed at horizontal moving.
3~153 cm / sec;
3cm/sec per step
72 cm / sec
AAS Speed
To set or modify AAS detecting speed.
Medium, Low
Medium
Up Accel.
To set or modify tool acceleration levels while the tool move
from endpoint to next start point at horizontal moving.
High, Medium,
Low
Medium
Up Speed
To set or modify tool up speed at horizontal moving.
3~153 cm / sec;
3 cm / sec per
step
72 cm / sec
Quality
To set or modify cutting quality.
While cutting small letter, set as “Small letter”.
While cutting in high speed, set as “Draft”.
For normal operation, set as “Normal”.
Draft (4.2G), Fair
(2.8G), Normal
(1.4G), Fine
(0.7G), Small
Letter (0.2G)
Normal
[ CUT TEST ]
Square Cut
To perform a cutting test at present blade position.
For more information, please refer to “4.3 Adjusting the
Cutting Force and Offset” to adjust blade force and cutting
speed.
Repeat AAS
Job
To repeat AAS jobs automatically without having to operate
on the computer side.
Please be noted that this feature is mainly applied to the
Single paper mode; please ensure a new piece of material
you wish to apply this feature on is loaded and the origin
repositioned to the first registration mark before starting.
When the first AAS job repeat completes, the user will be
offered the choice of “Repeat AAS Job Again”, please
press ”Online/Offline” to return to the main menu.
This option will appear after finishing reading all registration
marks.
Summary of Contents for ValueCut II Series
Page 60: ...Automatic Aligning System ValueCut USER MANUAL 60 VC2E A 00 Figure 5 1 Figure 5 2...
Page 111: ......
Page 112: ......
