Operation
ValueCut USER MANUAL
54
VC2E-A-00
4.
Then turn the roll downward to make an equal tension across the media.
(See Figure 4-16)
5.
Engage pinch rollers.
6.
Fixes roll media guide bushes on the roll holder to secure the roll media.
7.
The protrusion length of the blade should be longer than the thickness of the vinyl.
(Please check the “Blade Specification: About the Tool” in Appendix.) After you notice
all the above, you’ll enjoy your gigantic signs production!
4.6 When Completing the Cutting Job
After completing the cutting job, raise the sheet-loading lever, and then remove the material. You can
also cut off the finished job by the Safe Blade (a standard accessory) along the knife guide. (Figure 4-17)
Make sure that the media tension is
equally distributed from left to right. If the
media is not tight enough against the
platen, it will cause tracking problems.
Figure 4-16
Figure 4-17
Summary of Contents for ValueCut II Series
Page 60: ...Automatic Aligning System ValueCut USER MANUAL 60 VC2E A 00 Figure 5 1 Figure 5 2...
Page 111: ......
Page 112: ......
