MUTOH Blizzard, Installation Manual

Page: 37 / 68

Installation Guide Blizzard
37 AP-75261 – Rev. 2.0 – 19/12/07
Step 1 : Plug in the power cable to the inlet at the back of the printer.
Step 2 : Plug it in the power cable to the outlet
Important
•
D
O NOT ATTEMPT TO PLUG IN ELECTRICAL PLUGS WITH WET HANDS
. D
OING SO MAY RESULT IN ELECTRICAL
SHOCK
.
•
B
E SURE TO USE THE SPECIFIED VOLTAGE
(AC 100V-120V/220V-240V). O
THERWISE
,
ELECTRICAL SHOCK
OR FIRE MAY OCCUR
.
•
U
SE ELECTRICITY DIRECTLY FROM A POWER OUTLET
(AC 100V-120V/220V-240V). D
O NOT PUT MANY
LOADS ON ONE ELECTRICAL OUTPUT
. O
THERWISE
,
HEAT MAY BE GENERATED AND CAUSE FIRE
.
•
B
E SURE TO USE AN OUTLET WITH AN EARTH TERMINAL
,
AND USE THE TERMINAL CORRECTLY
. O
THERWISE
,
ELECTRICAL SHOCK OR FIRE MAY OCCUR
.
•
D
O NOT CONNECT EARTH CABLES IN THE FOLLOWING AREAS
:
► G
AS PIPES
. D
OING SO MAY CAUSE FIRE OR AN EXPLOSION
.
► E
ARTH TERMINALS FOR TELEPHONE LINES OR LIGHTNING RODS
. D
OING SO MAY CAUSE A LARGE FLOW
OF VOLTAGE IF LIGHTNING OCCURS
.
► W
ATER PIPES OR FAUCETS
. I
F THERE IS A PLASTIC PART IN THE PIPE
,
THE EARTH WILL NOT WORK
CORRECTLY
.
Caution
•
F
OLLOW THE INSTRUCTIONS BELOW WHEN HANDLING THE POWER PLUG
. O
THERWISE
,
FIRE MAY OCCUR
.
► W
IPE AWAY DUST AND ANY OTHER RESIDUE BEFORE INSERTING THE PLUG
.
► E
NSURE THAT THE PLUG IS FIRMLY INSERTED AS FAR AS IT WILL GO
.
•
E
NSURE THAT THE PLUG HAS BEEN DISCONNECTED FROM THE POWER SOCKET WHEN IT IS NOT USED FOR A
LONG TIME
.
•
E
ARTH WIRES MUST BE CONNECTED TO WIRES OR TERMINALS THAT FULFIL THE CONDITIONS
:
► E
ARTH TERMINALS OF POWER SOCKET
► E
ARTH WIRES WITH COPPER MORSEL THAT IS AT LEAST
650
MM UNDER GROUND
Notes
•
I
F YOU CANNOT USE EARTH TERMINALS OR FIND ANY OF THEM
,
CONTACT THE SHOP WHERE YOU BOUGHT
YOUR PRINTER
.
•
D
O NOT UNPLUG THE POWER CABLE WHEN THE PRINTER IS ON
. I
F THE POWER CABLE HAS BEEN UNPLUGGED
,
LEAVE THE PRINTER FOR AT LEAST
1
MINUTE BEFORE PLUGGING THE CABLE IN AGAIN
.