02/2014
_____________________________________________________________________________________________________________________
22
6. Configuration program
The illustration above shows the opening screen of the WINSMART configuration program for the MTP200
and MTP200 with the corresponding version and release number of the program.
The command
File
in the menu bar is used to access existing configuration files and for saving and printing of
the current configuration. Two of the three operating levels, which can be accessed by using the command
Permission
, are secured by passwords. The operating level for calibration of measure inputs and analogue
outputs has a special importance. Only after password input and the command
Calibration
it is possible to
access one of two masks.
To communicate with the WINSMART program it is necessary to enter the COM address in the field
PC
Interface
and
MTP address
(left area of the screen in the section
Interface
). A device with unknown address
can be identified by using the function
Search address
. After finding the device address the
Serial-No.
and
TAG-No.
will be shown.
Administration of access rights for three operating levels secured by codes and calibration for the measuring
input and analogue output. The WINSMART configuration program supports both MTP200 and MSK200.
.
For information about the MTP200, which will not be covered in the following description,
refer to the existing MTP200 manual.
The buttons arranged below offer access to configuration and parameter settings for the MTP200 input and
output. The desired settings for the SIL2 monitoring circuit can be made in the relevant screen with the button
System Controlling
. The
Diagnostic Manager
reports the status of the device and also saves faults that
arise even briefly. The
online display
offers the user a precise analogue and digital illustration of the
measured input magnitudes and output signals.
