SUSPENDERS (MA7650)
Suspenders are not required when using the MSD901, unless sizing dictates. However,
properly attached suspenders may improve the fit and mobility. The MSD901 is equipped
with attachment loops, on the Immersion Module, that accommodate the suspender
system. Remove and re-attach as required.
Suspender Attachment Instructions
Required materials: MSD901 and two suspenders.
a) Completely unzip the MSD901 entry zipper (Fig. 18)
b) Open the suit so that the (front and back) attachment loops are accessible (Fig.
19).
c) Attach the end of the suspender, with the buckle, to the suit’s front attachment
point by unpeeling the Velcro flaps and lifting the Velcro strap that is folded on
itself. Fold the flaps over the strap (so that hook Velcro faces hook Velcro). Pass
the suspender through the attachment loop. The strap end can now be folded
over itself so the Velcro patches close. To secure the suspender, wrap the Velcro
flaps around the edges of the strap and attach to Velcro on the opposite side of
the strap (Fig. 20).
FIGURE 20
15
FIGURE 18
FIGURE 19
Summary of Contents for MSD901
Page 1: ...MSD901 Industrial Dry Suit User s Manual ...
Page 2: ......
