STEP
8 Adding the outer shell
a) Lay the outer shell out flat with the chest zipper facing up. Lower the chest and
ankle gusset zippers. Completely loosen the wrist adjustment straps.
b) Fold the outer shell over at the waist exposing leg openings.
c) Feed the left leg of the thermal liner/immersion module assembly through the
left leg of the outer shell and pull it through. Repeat this procedure for the right
leg (see fig. 10).
d) Feed the left arm of the assembly through the left arm of the outer shell and
pull it through. Repeat this procedure for the right arm. Do not connect the wrist
interconnection zippers yet.
e) Pull the neck seal up to the neck of the outer shell.
STEP
9 Outer shell waist and waterproof zipper connection
a) Fold back the protective flaps of the outer shell to give access to the
interconnection zippers.
b) Line up the two ends of the lower interconnection zipper on the immersion
module with the corresponding zipper of the outer shell. Connect the two ends
and fasten them the length of the zipper (see fig. 11).
6
5
Immersion
Module
Foot
Outer Shell
Leg
FIGURE 10
Leg of the Thermal Liner/Immersion
Assembly Fed Through the Outer Shell
Immersion
Module
Interconnection
Zipper
Outer Shell
Interconnection
Zipper
Protective
Cover
FIGURE 11
Closing the Upper Interconnection Zipper between
Immersion Module and the Outer Shell
Summary of Contents for MSD901
Page 1: ...MSD901 Industrial Dry Suit User s Manual ...
Page 2: ......
