Musical Fidelity M1 SDAC, Instructions For Use Manual

Page: 11 / 47

ANALOGUE INPUTS & OUTPUTS
Issue 4 Page 11 of 47
AUX 1 input
To use the AUX1 input, press AUX 1 on the remote control.
To select from the front panel, press the volume control in to access the source select menu and rotate control
until AUXILLIARY 1 is next to the flashing square.
Note: Currently set input is indicated by a tick, which in the example below is AUX 2
Then press the volume control to confirm the input. The screen will change to show the new selected input.
AUXILIARY 1
Analogue
√ AUXILIARY 2
AUX 2 input
To use the AUX2 input, press AUX 2 on the remote control.
To select from the front panel, press the volume control in to access the source select menu and rotate control
until AUXILLIARY 2 is next to the flashing square.
Then press the volume control to confirm the input. The screen will change to show the new selected input.
AUXILIARY 2
Analogue
©AUXILIARY 2
The chosen input is remembered even if the mains is removed
Outputs Headphones and PRE-OUTs
When headphones are plugged in, the PRE OUTS will mute (effectively muting signal to speakers) and unit will
switch to a
different
stored volume setting.
This new setting is in operation for as long as the headphones remain plugged in. The volume may therefore be
independently set for comfortable headphone listening.
Once the headphones are removed, the preamp outputs are restored and volume is reset to the previous level.
The headphone volume level is also stored for next time headphones are plugged in.
The two level settings are remembered even if the mains is removed