Once you're happy with the orientation of the device, it's time to solder the rest of the legs. If you're
using a flux pen, apply some flux to the legs of the IC. This will help the solder flow into the joints.
Start on the legs on the other side from the one you've already soldered. Put the tip of the soldering
iron at the end of the pad & apply a small amount of solder. The solder should flow down the pad &
over the IC leg. Repeat this for the other pins on that side of the IC, then rotate the board & do the
other pins.
MTM SimpleEQ 0805 build doc v1.1
Page 21
Illustration 23: NE5532 with one pin soldered
Illustration 24: NE5532 with 5 pins soldered.
