© Munters Corporation, August 2021
12
QM1231r10
Step 9
Place all 4 cone sections on a flat surface with tabs from one facing slots of the next.
See Figure 9A
.
Curl up tab end of first cone section and insert tabs up into slots in the next cone section. A mallet may
be needed to seat slots over tabs completely.
See Figure 9B.
Repeat this until all 4 cone sections are
connected and laying flat.
Installation Instructions
Chapter 2
Step 10A
Fasten each of the joints in the single outer hole using (1) Short Bolt [D] and Nut [G], with the nut on the
side with the tabs. At the inner pair of holes of each joint attach (1) Cone Support Bracket to the inner
hole using (1) Short Bolt [D] and Nut [G] with the bolt head on the side with the tabs.
See Figure 10A.
Figure 9A
Figure 10A
Nut [G]
Figure 9B
Outer Hole
Short Bolt [D]
Short Bolt [D]
Inner holes
Nut [G]
Cone Support Bracket
2.3 Cone Installation
