© Munters Corporation, August 2021
18
QM1231r10
Step 18
Use a straight edge or level to check alignment of the
Propeller Sheave, Tensioner Pulley and the Motor Sheave.
If needed, adjust position of Motor Sheave so the 3 pulleys
line up. Once Motor Sheave is aligned tighten set screw to
75 in-lbs [9 N-m] torque.
See Figure 18.
Figure 18
Level
Motor Sheave
Tensioner Pulley
Propeller Sheave
Installation Instructions
Chapter 2
Figure 17B
Stiff ener
Step 17B
Using channel locks and/or a hammer twist the Motor Bracket Stiffener so that the holes in the bracket lay
flat against the framing. Then secure the bracket to the framing using (1) Lag Screw [H].
See Figure 17B.
Framing
Lag Screw [H]
