© Munters Corporation, August 2021
10
QM1231r10
Step 5
Attach the 3” Idler Pulley to the Tensioner Arm using Bolt [K]. Then attach the Tensioner/Pulley Assembly to
the Tensioner Bracket using Bolt [B] and Splitlock Washer [C]. Finger tighten only at this time.
See Figure 5.
Figure 5
Installation Instructions
Chapter 2
Bolt [B]
Splitlock Washer [C]
Tensioner Pulley
Tensioner Arm
Bolt [K]
Step 6
Attach Drip Shield to bottom of framed opening using (3) Barn Screws (Not Provided).
See Figure 6A and 6B.
If
a 4” wall is used a support board must be installed as shown in
Figure 6B
.
Be sure not to deform Drip Shield when
installing screws.
Figure 6A
Barn Screw
(Not Provided)
Drip Shield
Figure 6B
Barn Screw
(Not Provided)
Drip Shield
Drip Shield
Barn Screw
(Not Provided)
Support board
