MCS300
4
Operation
4.1 General
The dehumidifier has three operating modes, see
.
Man
: The dehumidifier’s fans, rotor and reactivation heater operate continuously.
Auto1
: The dehumidifier’s fans, rotor and reactivation heater are started/stopped by the humidistat.
Auto 2
: The dehumidifier’s fans and rotor operate continuously. The reactivation heater is started and
stopped by the humidistat only. This mode of operation is used to maintain air circulation. If relative
humidity rises to the humidistats setpoint, the reactivation heater starts. The reactivation heater stops when
relative humidity drops below the setpoint.
NOTE!
For the dehumidifier to function in Auto 1 and 2, a single stage humidistat must be connected to the unit.
See section 3.10, Connecting the humidistat.
NOTE!
In humidistat operation mode, there is a built-in function that delays re-start of the dehumidifier for 2
minutes. See section 4.3.3, Automatic operation.
Man
Auto 1
Auto 2
KWH
Temp
C
D
0 1
F
G
H
E
A
B
Figure 4.1 Control panel, on-off switch and humidistat socket
A. Control panel
E. Storage compartment
B. Dehumidifier
F. On-off switch
C. Measurement selector
G. Humidistat socket
D. Operating mode selector
H. Power cable
4.2 Quick stop
Stop the unit with the on-off switch at the front of the unit, or pull out the plug from the wall outlet.
190TEN-1027- F1404
Operation
12
Summary of Contents for MCS300
Page 28: ...www munters com ...