Munters HCUw, Operating & Maintenance

Page: 97 / 122

67
3 G 3 J V L i s t o f P a r a m e t e r s
Chapter 9
Parame-
ter No. Name Description Set-
ting
range
Unit
of set-
ting
Default
setting Changes
during
opera-
tion
Refer-
ence
page
n30 Frequency ref-
erence upper
limit
0 to
110 1% 100 No 5-9
n31 Frequency ref-
erence lower
limit
Used to set the upper and lower frequency
reference limits in percentage based on
the maximum frequency as 100%.
Note If n31 is set to a value less than the
minimum output frequency (n14), the
Inverter will have no output when a
frequency reference less than the
minimum output frequency input is
input.
0 to
110 1% 0 No 5-9
n32 Rated motor
current
Used to set the rated motor current for mo-
tor overload detection (OL1) based on the
rated motor current.
Note Motor overload detection (OL1) is
disabled by setting the parameter to
0.0.
Note The rated motor current is default to
the standard rated current of the
maximum applicable motor.
0.0 to
120%
of
rated
output
cur-
rent of
the In-
verter. 0.1 A Varies
with
the ca-
pacity. No 5-2
n33 Motor protec-
tion characteris-
tics
Used to set the motor overload detection
(OL1) for the electronic thermal character-
istics of the motor.
0: Protection characteristics for general-
purpose induction motors
1: Protection characteristics for inverter-
dedicated motors
2: No protection
Note If a single Inverter is connected to
more than one motor, set the param-
eter to 2 for no protection. The pa-
rameter is also disabled by setting
n32 for rated motor to 0.0.
0 to 2 1 0 No 6-14