Multitech MultiVOIP MVPFXS-16, User Manual

Page: 38 / 165

Connectivity Test MultiVOIP FXS Quick Start Guide
38
Connectivity Test
The procedures “Phone/IP Starter Configuration” and “Phonebook Starter Configuration” must be
completed before you can do this procedure.
1. These connections must be made:
MultiVOIP to local phone station
–OR--
MultiVOIP to extension of key phone
system
MultiVOIP to command PC
MultiVOIP to Internet
2. Inbound Phonebook and Outbound Phonebook must both be set up with at least one entry in each.
These entries must allow for connection between two voip units.
3. Console messages must be enabled. (If this has not been done already, go, in the MultiVOIP GUI, to
Configuration | Logs and select the “Console Messages” checkbox.
4. Make sure that the COM port connection is free so that the HyperTerminal program can use it.
5. Open the
HyperTerminal program.
6. Use HyperTerminal to receive and record console messages from the MultiVOIP unit. To do so, set up
HyperTerminal as follows (setup shown is for Windows NT4; details will differ slightly in other MS
operating systems):

In the upper toolbar of the HyperTerminal screen, click on the Properties button.

In the “Connect To” tab of the Connection Properties dialog box, click on the Configure
button.

In the next dialog box, on the “General” tab, set “Maximum Speed” to 115200 bps.

On the “Connection” tab, set connection preferences to:
Data bits
: 8
Parity
: none
Stop bits
: 1

Click OK twice to exit settings dialog boxes.
7. Make VOIP call on a local phone line accessing PSTN directly or through key system..