Multitech CC1600 Series, Owner'S Manual

Page: 66 / 76

66
MultiModemBL Owner’s Manual
Appendix A-Compliance with BABT Requirements\
Compliance with BABT Requirements
Approved for connection to telecommunications system specified in the instructions for use subject to
the conditions set out in them.
Warning: Interconnection directly, or by way of other apparatus, of ports marked "SAFETY
WARNING see instructions for use" with ports marked or not so marked may produce hazardous
conditions on the network. Advice should be obtained from a competent engineer before such a
connection is made.
This apparatus has been approved for the use of the following facilities:
• Auto-calling
• Loop disconnect and MF dialing
• Phone number storage and retrieval by a predetermined code
• Operation in the absence of proceed indication
• Automatic storage of last number dialed
• Tone detection-busy
• Auto clear from the originating end
• DTR dialing
• Modem
• PBX timed break register recall
European Low Voltage Directive
When correctly installed and maintained, the modem will present no hazard to the user. When
correctly installed the modem will be connected to the PSTN or a PW and to a Data Terminal
Equipment (DTE), whose modem connections comply with CCITT recommendation V28. The DTE
connections are therefore taken to be safe voltages (less than ± 30 volts).
The main power source shall be installed near to the equipment and shall be easily accessible. The
plug that connect to the apparatus to the main power supply must be fitted with a 5A fuse that
complies with BSI1362.
Ports which are capable of connecting to other apparatus are defined as SELV. To ensure
conformity with EN41003, ensure that these ports are only connected to ports of the same type on
other apparatus.