Multitech CC1600 Series, Owner'S Manual

Page: 39 / 76

39
Chapter 4 - Modem Commands, S-Registers & Result Codes
COMMAND: Sr?
VALUES: r = 0-11, 13, 15-17, 24-26, 29, 30, 32, 34, 36, 37, 48
DEFAULT: n/a
DESCRIPTION: Reads value of S-Register “r” and displays value in 3-digit
decimal format.
COMMAND: $SBn
VALUES: n = speed
DEFAULT: $SB115200 bps
DESCRIPTION: $SB300 selects 300 bps at serial port.
$SB1200 selects 1200 bps at serial port.
$SB2400 selects 2400 bps at serial port.
$SB4800 selects 4800 bps at serial port.
$SB9600 selects 9600 bps at serial port.
$SB19200 selects 19,200 bps at serial port.
$SB38400 selects 38,400 bps at serial port
$SB57600 selects 57600 bps at serial port.
$SB115200 selects 115200 bps at serial port.
COMMAND: $SPn
VALUES: n = 0 or 1
DEFAULT: $SP0
DESCRIPTION: $SP0 disables UUCP spoofing.
$SP1enables UUCP spoofing.
COMMAND: &SFn
VALUES: n = 0 or 1
DEFAULT: &SF0
DESCRIPTION: &SF0 selects DSR follows CD.
&SF1 selects DSR independent.
COMMAND: &Sn
VALUES: n = 0, 1 or 2
DEFAULT: &S1
DESCRIPTION: &S0 forces Data Set Ready On.
&S1 lets Data Set Ready act normally.
&S2 Data Set Ready drop is regulated by
S24 on disconnect.
COMMAND: T
VALUES: n/a
DEFAULT: Tone Dial
DESCRIPTION: Modem will tone-dial numbers following the T.
COMMAND: &Tn
VALUES: n = 4 or 5
DEFAULT: &T5
DESCRIPTION: &T4 selects Enable Response to Request for Remote Digital
Loopback.
&T5 selects Disable Response to Request for Remote Digital
Loopback.