Multitech CC1600 Series, Owner'S Manual

Page: 41 / 76

41
Chapter 4 - Modem Commands, S-Registers & Result Codes
COMMAND: #Xn
VALUES: n = 0 or 1
DEFAULT: #X0
DESCRIPTION: #X0 selects single XOFF character sent until XON level returns.
#X1 selects multiple XOFF characters after buffer level is full.
COMMAND: Yn
VALUES: n = 0 or 1
DEFAULT: Y0
DESCRIPTION: Y0 disables sending or responding to long space “break”.
Y1 enables sending or responding to long space “breaks”.
COMMAND: Z
VALUES: n/a
DEFAULT: n/a
DESCRIPTION: All configuration parameters are reset to default values.
COMMAND: , (Comma)
VALUES: n/a
DEFAULT: n/a
DESCRIPTION: Causes pause during dialing.
COMMAND: ; (Semi-Colon)
VALUES: n/a
DEFAULT: n/a
DESCRIPTION: Causes return to Command Mode after dialing.
COMMAND: ! (Exclamation)
VALUES: n/a
DEFAULT: n/a
DESCRIPTION: Causes modem to flash On-Hook.
COMMAND: @
VALUES: n/a
DEFAULT: n/a
DESCRIPTION: Causes modem to wait for ringback, then 5 seconds of silence
before processing next part of command.
COMMAND: +++AT<CR>
VALUES: n/a
DEFAULT: n/a
DESCRIPTION: In-band Escape Sequence. Places modem in Command
mode while still remaining On- Line. Enter +++ followed
by the letters A and T, up to ten command characters, and
a RETURN.
COMMAND: BREAK AT<CR>
VALUES: n/a
DEFAULT: n/a
DESCRIPTION: Out-of-band Escape Sequence. Places modem in Command mode
while still remaining On- Line. Not preceded by AT. Enter a BREAK
signal, followed by the letters A and T, up to sixty command
characters, and hit RETURN.