Multiplex Hyper Warwick R290, Installation Manual

Page: 16 / 44

16
Section 3
8. If required, connect a mains water supply to the STILL IN connection and the STILL
OUTLET connection to the appropriate line within the python. Ensure the outlet line
to the python is insulated.
9. Connect the syrup lines within the python to the connections labelled SYRUPS OUT
HQVXULQJWKHVHFRQQHFWLRQVDUHLQVXODWHGZLWKVXLWDEOHDUPDȵH[
10. Connect the other end of the python to the dispense head.
Note:
Ensure the recirculation run is not excessive, and the python is routed away from
external heat sources. The maximum lift for the recirculation pump is 6m. The maximum
recommended run is 12 metres.
Any unused syrup coils should remain capped both for personal protection and to prevent
the ingress of debris.
11. When all connections have been made, turn on the CO2 supply to the unit and
DOORZWKHV\VWHPWRȴOOZLWK&2/LIWWKHUHOLHIYDOYHRQWKHWRSRIWKHFDUERQDWRU
bowl in the unit to remove any trapped air. Ensure there are no leaks from any of
the joints.
12. Operate the dispense valves to expel any air from the Python ensuring there are no
leaks from any of the connections. Rectify if any are found before proceeding.
13. Ensure the soda pump switch is in the OFF position and the carb pump switch is in
the OFF position.
14. Turn on the water supply to the unit again checking for leaks.
15. Plug the Icecore 10 unit into the mains supply and switch the unit on on. There is
an approximate 1 minute delay from switching the cooler on until the compressor
starts.
Note: If the unit is a water cooled version, ensure the glycol lines prime correctly and that
the glycol module is topped up to the correct level.
(Refer to HEAT DUMP – GENERAL GUIDELINES & GLYCOL MODULE INSTALLATION
GUIDELINES ON PAGES 19-21)
16. Switch the carbonator pump on via the switch ensuring that the carbonator bowl
ȴOOVDQGWKHSXPSFXWVRXWDXWRPDWLFDOO\
17. Operate the dispense valves to bleed any gas pockets from the python and to
HQVXUHWKHȵRZDQGUHWXUQOLQHVDUHȴOOHGZLWKFDUERQDWHGZDWHU