3
Product description
Applications on the terminal
12
V5.20170221
31302713-02-EN
USB port for:
- USB memory device [
Port A
CAN bus port for:
- ISOBUS basic vehicle harness [
- Connection to the tractor CAN bus
Port C
Serial port for:
- GPS receiver [
- GPS TILT-Module
- Lightbar [
Port B
See section: Pin assignment Port B [
ETH port
M12 port for:
- Ethernet
CAM port
Port for an analog camera
Slot with the SD card
Applications on the terminal
The terminal is delivered with a range of installed application (apps). Most of these can be used
immediately. Even the non-activated applications can generally be tested for 50 hours. If a specific
application works well for you, a license can be ordered from Müller-Elektronik to activate the full
version of the application.
The full versions of the following applications are installed on the terminal:
▪
- Service application.
The Service application allows you to:
– Configure the terminal.
– Enable and disable other applications.
– Enter license activation codes.
– Enable drivers for connected devices.
– Configure the GPS settings.
▪
- TRACK-Leader application.
The TRACK-Leader application allows you to work the field on exact parallel tracks.
The app contains several modules for which a license can also be activated:
– SECTION-Control: Automatic section control in order to minimize overlaps.
– TRACK-Leader AUTO: Automatic vehicle steering on the field.
– TRACK-Leader TOP: Automatic vehicle steering on the field.
▪
- Tractor-ECU application
The Tractor-ECU application is used to record all settings around the tractor.
Here, you can e.g.:
– Enter the position of the GPS receiver.
– Set the GPS receiver as the speed signal source.
– Select which sensor signals are received by the terminal.
– View the speed and PTO shaft rotational speed on the screen.
3.4
Full versions
