Virtual ECU application
Parameters
9
31302713-02-EN
V5.20170221
61
Sections
Opens a screen where you can enter the width of the individual sections on the implement.
Machine model
This parameter influences how the working bar follows the arrow in TRACK-Leader. The
configuration improves the precision of the recording of applied areas in curves.
After each change, you also need to adjust the geometry.
Possible values:
▪ "mounted"
Setting for implements that are mounted on the tractor three-point hitch.
▪ "trailed"
Settings for implements trailed by a tractor. The working bar is guided like a trailer behind a
tractor.
Geometry
The geometry contains a series of dimensions that help to properly display the vehicle-implement
combination in TRACK-Leader and determine its position.
To call up the geometry, tap the function icon:
Calls up the machine geometry.
Screen for entering the geometry for different machine models
A
Mounted
:
Distance between the coupling point and the work point of the machine.
Trailed
:
Distance between the coupling point and the pivot point of the machine.
For single-axle trailers, the pivot point is located at the centre of the axle, for tandem trailers between
two axles. For planters/seeders, cultivators and other soil tillage implements, the pivot point must be
determined individually.
B
Mounted
:
Not available
Trailed
:
Distance between the pivot point of the machine and the work point.
C
Only for spreaders: Working Length
D
Lateral offset
If the mounted implement is offset to the left in the direction of travel, enter a negative value. For
example: - 50 cm.
