Tractor-ECU application
Results
8
31302713-02-EN
V5.20170221
57
Distance between the centre of the vehicle and the GPS receiver, on the left-right axis.
If the receiver is installed on the left side, enter a negative value.
Users of
TRACK-Leader AUTO®
: The position of the GPS receiver must also be entered and
calibrated in the steering job computer. For this reason, the
and
boxes are greyed-out and
cannot be edited.
Distance between the GPS receiver and the rear axle of the vehicle.
Distance between the rear axle and the rear mounting or attachment point (e.g.: three-point hitch).
To configure the tractor geometry:
1.
- Open the Tractor ECU application.
2.
Tap "Settings".
⇨
The existing tractor profiles appear.
⇨
If a tractor profile is activated, most of the other function icons are greyed-out.
3.
- To edit a tractor profile or to create a new one, you must deactivate the activated
tractor profile.
4.
Tap on the tractor profile to be edited.
5.
- Call up the parameter list.
⇨
The parameters are displayed.
6.
- Open the tractor geometry screen.
7.
Enter the distances explained on the figure above.
Results
The Tractor ECU application documents the work in two counter groups:
▪ Trip counter
▪ Task-related counter
Trip counter
Counter designation
This is documented
Applied distance
Distance during which the working position sensor was
activated.
Applied area
Area during which the working position sensor was activated.
The Tractor ECU application uses the set working width as a
basis for the calculation of the area.
Working time
Time during which the working position sensor was activated.
To clear a trip counter:
1.
- Open the Tractor ECU application.
Procedure
8.4
8.4.1
Procedure
