muli ST+PX, User Manual

Page: 66 / 75

130 131
The e-muli has a very robust double-legged stand from the company Ursus, with
which the e-muli can be parked tilt-proof. This stand may be loaded with up to
80kg.
Note that the double leg stand is subjected to high loads and wears out over
time and must be replaced in due course. Through frequent use and high loads,
the stand can, among other things, lose some of its clamping force and then
hang down a little further in the folded state. Make sure that the stand does not
start to drag on the tire. It is very important to regularly check the screw con-
nection of the double leg stand. Check the tightness of the screw connection
of the stand to the frame before every ride! An incorrectly tightened screw can
cause damage to both the stand and other components. Among other things, a
stand that is not tight can cause the stand to twist and start grinding on the rear
tire. This dragging, in turn, can cause the tire to wear and quickly crack or burst.
Parking
To place the e-muli on the double leg stand, press the stand onto the floor with
your foot. Make sure that both feet touch the ground and that you do not push
the e-muli backwards on one side over one stand leg. In general, but especially
with heavy loads, it is helpful to lift the e-muli slightly upwards by the saddle whi-
le you push it backwards onto the stand. The e-muli is jacked up somewhat when
parked on the stand and must therefore be pulled backwards with some force.
To get the e-muli back into driving position from the parking situation, place
Load
Note the load limit of 80 kg. In the parking position with the stand folded out,
this means that the e-muli can be loaded with a maximum of 47 kg so as not to
exceed the maximum load of the stand.
80 kg minus the
33 kg dead weight of the e-muli
= 47 kg possible load with folded out stand
Do not sit on the saddle of the e-muli with the stand
unfolded.
Note that the double leg stand is subjected to high
loads and wears out over time and must be replaced in
due course.
Check the tight fit of the screw connection of the stand
to the frame before each ride! An incorrectly tightened
screw can cause damage to both the stand and other
components.
one foot in front of a stand leg and simply push the e-muli forward. No lifting is
required here.
You can also find more info on parking with the double leg stand here:
https://www.youtube.com/watch?v=MYRw0seoO4M
Double-leg Stand