MTS Systems THIR-6780 Series, Configuration Manual

Page: 67 / 96

66
●Preset barcode menu
It is not capable to setup only barcode menu.
●Setup by Sending Command
Send serial commands to the scanner from host computer as following sequence.
1) PREM=2[CR]
2) SET=PRED??ALFA????[CR]
3) SET=PREN10[CR]
4) WSETS[CR]
Transmitting Preset Status
Output the current preset setting status. To output the status, read the barcode menu of preset status transmission
below.
Transmitting Preset Status
Command ?pre [CR]
Output Example
PREM=0 (0:non 1:power on 2:saved)
PRESET LENGTH:41
DATA(HEX):
31 32 33 3F 3F 3F 3F 3F 3F 3F
3F 41 42 43 43 44 45 03 04 05
3F 3F 3F 3F 3F 3F 3F 3F 46 47
48 49 3F 3F 3F 3F 3F 3F 39 31
30
DATA(ASCII):
123????????ABCCDE***????????FGHI??????910
Output Format
PREM=a (0:non 1:power on 2:saved)[CR]
PRESET LENGTH:b[CR]
DATA(HEX):[CR]
XX XX XX XX XX XX XX XX XX XX[CR]
XX XX XX XX XX XX XX XX XX XX[CR]
XX XX XX XX [CR]
DATA(ASCII):[CR]
xxxxxxxxxxxxxxxxxxxxxxxx
a
: Preset mode
b : The number of Preset data digits
XX
XX …
: Preset data characters, displayed as Hexadecimal number pairs
xxxxxx…
: Preset data character( ASCII/JIS Character code)
Preset data is including of control character, the control characters converted by “*”.