MTS Systems THIR-6780 Series, Configuration Manual

Page: 16 / 96

15
・
Output order for multiple symbols reading
To set the output order (transmitting data order) for multiple symbols reading, scan several symbols in the proper
sequence below.
Unless otherwise specified, if an error occurs during a scanning sequence, just re-scan the correct parameter.
[Procedure]
(1) Set
the maximum number of symbols to be decoded for a single trigger input. (previous page).
(2) Set the separator character to be inserted between the symbol data (previous page).
(3) Set the sorting method ( none, in the order of decoding, symbol lengths, specified characters, or
symbologies)
(4) Select the output sequence number to be programmed (up to 4).
(5) Set the item to be set (symbol lengths, First Character, Second Character, Type of Symbologies).
(6) Set the appropriate Data.
(a) To set the symbol lengths, use the
”Character Data” on page 27.
(b) To set the first or second character, use the “Character Code” on page 26.
(c) To set the symboogy
, use the “Symbology type” on page 29 and 30.
(7) When setting is complete, s
can the “Confirm” symbol to accept the changes or “Cancel” to revert back to the
previous settings. These symbols can be found on page 30.
(8) Repeat steps (4) through (7) to set the remaining items.
(9) Finally scan
the “Save Settings” symbol to save the settings to the unit’s non-volatile Flash memory.
Note: Multiple RSS composite codes cannot be decoded from a single image, but a single RSS composite
code may be decoded with other types of symbologies.
・
Sorting method
Not specified (in order of decoding)
(*)
Symbol lengths
Specified characters Type of symbologies