Matrix
System
®
83
Testing a Video Switching System
1.
Hook up one Video Source (Camcorder or VCR), connecting video and audio signals to the
correct Switching Modules. (See Component Installation, pages 77-78, for recommended
procedures and options.)
2.
Hook up one monitor or television. (See Component Installation, pages 77-78, for
recommended procedures and options.) Activate the Video Source. If the monitor has stereo
audio, test right and left channels by adjusting balance controls.
3.
Now, hook up and test, one at a time,
one component each
for every Chain in your Display,
to assure that all signal buses are correctly hooked up. Correct any problems before moving
on to the next step.
4.
Now if your Display contains more than one Monitor or Television, hook them up and
test them one by one. Test right and left channels. From
this point, you will always be
testing new components with components that you already know are connected properly
and working.
5.
If the audio signal is to be played through separate speakers or a sound system, follow the
steps for Home Audio, above, to hook up and test that part of the system with a single
Video/Audio Source.
6.
Now, go back and hook up and test all Video Sources, one at a time, Chain by Chain. Use
the same Monitor (and set of Speakers , if used) to test all Sources. Hook up all the
Camcorders in a Chain before moving on to the VCRs, for example.
7.
And now that everything works perfectly,
open your doors and start selling!
Summary of Contents for Matrix System 1210
