8
User Manual | MTI 401 & 400
Unpacking and Set-up
1. remove shipping straps,
shipping box, and other
boxes from the pallet.
2. remove (4) shipping bolts
with 7/16" end wrench.
3. remove braces from the
top of the baseplate.
4. Slide chair off pallet. To
move equipment, lift only
from the equipment’s main
structure. recycle or re-use
pallet.
5. plug the power cord into
an appropriately marked
receptacle (401 only).
6. attach the upholstery flap
to the back of the calf pad.
align the calf pad with the
foot loop and attach with
the 4 screws from behind.
7. attach the flap to the end
of the seat cushion.
8. align the seat cushion
with the seat section of
the chair and press into
place. verify the cushion is
centered.
For Concrete Floors
For Wood Floors
9. align the back cushion
with the back section of
the chair and press into
place. verify the cushion is
centered.
10. attach the flip-up arm
upholstery following the
instructions provided in the
upholstery kit.
11. If teardrop baseplate is not purchased, install the floor
clips at 3 points around the base plate. For wood floors
use only the lag bolts. For concrete floors use the lag
bolts and lag shield. To install lag shield drill 1/2” diameter
hole deep enough to insert the lag shield. Tighten lag
bolts with 7/16” wrench.
For chairs purchased with teardrop stabilizer plate, see
teardrop stabilizer plate instructions.
