MST Impact NS5001, User Manual

Page: 63 / 118

5.4.3 Rebooting or Restoring the Network Device
The
System
configuration screen enables the device to be rebooted or restored to the factory default
settings.
Click Reboot the Device to reboot the device. Any unsaved settings on the device will be lost and the
connection will terminate.
Click Restore all Settings to the Factory Defaults to restore the device to default settings. All current
settings will be erased.
5.4.4 Upgrading Firmware
Device Firmware can be upgraded from the
Firmware
upgrade screen as shown below. The firmware is
a binary (.bin) file format.
Note:
• WAC 1 must be upgraded before WAC 2. Complete steps 1-4 for for every WAC on the network
that you are upgrading, then move onto step 5.
• Firmware upgrades may reset the network device to default factory settings (please refer to the
firmware release notes to determine if this will occur).
• It is STRONGLY recommended to install ICA 1.4.1 (or greater) at the site and use the central
configuration management capability to re-apply device settings. See
Device Management
Overview on page 86 for more detailed instructions.
• For devices that are not managed by the ICA, configuration settings can be saved before updating
firmware and restored after the update from the
TOOLS > ADMIN screen. For more
information, see Saving and Restoring Configuration Settings on page 60.
NS50 User Guide 63 Revision C
Configuration Using the Web Interface