MSR MSR145W2D, User Manual

Page: 9 / 27

MSR Electronics GmbH • Mettlenstrasse 6 • CH-8472 Seuzach, Switzerland
Phone +41 52 316 25 55 • info@msr.ch • www.msr.ch • www.datalogger.shop
© MSR Electronics GmbH, 2020-03-12. All rights reserved. 9

To send the current measurement values to the local application via an existing network,
you must connect the logger to this wireless local network (WiFi). The network does not
need to have Internet access.

Enter the configuration data required by the data logger in the setup program of the MSR
PC software under "WiFi":
 To set up the MSR145W2D connect a suitable PC to the independent network.
 Start the MSR PC program (download and installation: refer to www.msr.ch/
en/support/pcsoftware)
 Connect the MSR145W2D to the PC using the USB cable (refer also to the
MSR145W2D quick start guide, www.msr.ch/msr145w2d).
 Run setup.
 "WiFi” tab
 Please enter settings (see also Annex A2 ):
 Network (SSID): Name of the WiFi network in which the logger should be
integrated.
 Network Key (WPA 2): Enter the corresponding WiFi password for WPA 2.
 Destination: URL -> local IP-adresses as target to choose.
For testing the WiFi connection for the first time, activate the WiFi of the logger connected to the
cable via the "
Activating status" tab. To check, the status of the WiFi connection of the logger
must then be " read ".
WiFi password
WiFi name
Current IP address of the PC,
local area network