MSR Electronics GmbH • Mettlenstrasse 6 • CH-8472 Seuzach, Switzerland
Phone +41 52 316 25 55 • [email protected]
• www.msr.ch
• www.datalogger.shop
© MSR Electronics GmbH, 2020-03-12. All rights reserved.
16
Appendix A2: WiFi setup in the MSR PC program
Connect the MSR145W2D to the PC using a USB cable
Start the MSR PC program (download and installation: refer to
www.msr.ch/en/support/pcsoftware
)
Run setup
"WLAN/WiFi” tab
Enter settings:
Version: For information only, no input required.
MAC address: For information purposes, the logger-specific MAC address (media
access control address) is entered here, which acts as the hardware address of the
logger network adapter, which serves as the unique identifier of the logger in the
computer network.
Network (SSID): Name of YOUR WiFi network in which the logger should be
integrated.
Network Key (WPA 2): Enter the WPA 2 type WiFi password.
Notice: A password already stored in the logger will not be read out by the setup
program and will be overwritten by entering a password (to enter a password, please
check "Write key” box).
Destination: Enter the global URL of the server name (e.g. msrsmartcloud.com -
button "URL") to which the measurement data should be sent (Internet connection
required). As an alternative, the IPv4 address of the PC (determined, Appendix A1) to
which the measured logger data should be sent can be entered here. By selecting the
"Local IP addresses" button, the local PC network addresses directly available in the
network will be suggested.