MSR Electronics GmbH • Mettlenstrasse 6 • CH-8472 Seuzach, Switzerland
Phone +41 52 316 25 55 • [email protected]
• www.msr.ch
• www.datalogger.shop
© MSR Electronics GmbH, 2020-03-12. All rights reserved.
5
The logger's WiFi module on the MSR145W2D is autonomously activated and deactivated for the
period of use:
Press the data logger button to activate the display. Press and hold the button
again until the "WiFi" option appears.
-> Release and press the button again: The data logger now connects to the WiFi
network.
Press the button again to deactivate the logger's WiFi module.
By pressing and holding the button again, the "State" option appears. The OLED
display shows the same setup status information as described above.
1.2. Sending data through an additional WiFi network to the MSR SmartCloud
In this option a standalone WiFi network and internet access using the mobile web are
established – e.g. through a Fritz!Box. In order to be able to send the current measurement
values and/or recorded data to the MSR SmartCloud via an independent network with a wireless
connection established specifically for the measurement task, you must connect the logger to this
wireless local area network (WiFi). The network
must
have Internet access (e.g. via LTE).
Appendix A4
provides a description of how to set up an independent WiFi connection
using as an example the Fritz!Box 6820 LTE in conjunction with a corresponding mobile
phone SIM card.
Enter the configuration data required by the data logger in the setup program of the MSR
PC software under "WiFi":
To set up the MSR145W2D connect a suitable PC to the independent network.
Start the MSR PC program (download and installation: refer to
www.msr.ch/
en/support/pcsoftware)
Connect the MSR145W2D to the PC using the USB cable (refer also to the
MSR145W2D quick start guide,
www.msr.ch/msr145w2d
).
